Define them according to the ISA manual, in order to enable matching the
sub-exceptions for humanization purposes later.
Signed-off-by: WANG Xuerui <git@xen0n.name>
Signed-off-by: Huacai Chen <chenhuacai@loongson.cn>
While interrupts are assigned ECodes `64 + interrupt number`, all
existing use sites of interrupt numbers want the 64 subtracted.
Re-arrange the definitions so that the actual interrupt number is used
everywhere, and make EXCCODE_INT_END inclusive as it is more intuitive
that way.
While at it, according to the asm/loongarch.h definitions, the total
number of architectural interrupts should be 14, but various other
places indicate otherwise (13 or 15). Those places have been adjusted
to 14 as well for consistency.
Signed-off-by: WANG Xuerui <git@xen0n.name>
Signed-off-by: Huacai Chen <chenhuacai@loongson.cn>
Not all LoongArch processors support CRC32 instructions. This feature
is indicated by CPUCFG1.CRC32 (Bit25) but it is wrongly defined in the
previous versions of the ISA manual (and so does in loongarch.h). The
CRC32 feature is set unconditionally now, so fix it.
BTW, expose the CRC32 feature in /proc/cpuinfo.
Cc: stable@vger.kernel.org
Signed-off-by: Huacai Chen <chenhuacai@loongson.cn>
Use the generic ptrace_resume code for PTRACE_SYSCALL, PTRACE_CONT,
PTRACE_KILL and PTRACE_SINGLESTEP handling. This implies defining
arch_has_single_step() and implementing the user_enable_single_step()
and user_disable_single_step() functions.
LoongArch cannot do hardware single-stepping per se, the hardware
single-stepping it is achieved by configuring the instruction fetch
watchpoints (FWPS) and specifies that the next instruction must trigger
the watch exception by setting the mask bit. In some scenarios
CSR.FWPS.Skip is used to ignore the next hit result, avoid endless
repeated triggering of the same watchpoint without canceling it.
Signed-off-by: Qing Zhang <zhangqing@loongson.cn>
Signed-off-by: Huacai Chen <chenhuacai@loongson.cn>
Use perf framework to manage hardware instruction and data breakpoints.
LoongArch defines hardware watchpoint functions for instruction fetch
and memory load/store operations. After the software configures hardware
watchpoints, the processor hardware will monitor the access address of
the instruction fetch and load/store operation, and trigger an exception
of the watchpoint when it meets the conditions set by the watchpoint.
The hardware monitoring points for instruction fetching and load/store
operations each have a register for the overall configuration of all
monitoring points, a register for recording the status of all monitoring
points, and four registers required for configuration of each watchpoint
individually.
Signed-off-by: Qing Zhang <zhangqing@loongson.cn>
Signed-off-by: Huacai Chen <chenhuacai@loongson.cn>
Current cache probe and flush methods have some drawbacks:
1, Assume there are 3 cache levels and only 3 levels;
2, Assume L1 = I + D, L2 = V, L3 = S, V is exclusive, S is inclusive.
However, the fact is I + D, I + D + V, I + D + S and I + D + V + S are
all valid. So, refactor the cache probe and flush methods to adapt more
types of cache hierarchy.
Signed-off-by: Huacai Chen <chenhuacai@loongson.cn>
