mirror of
https://github.com/Ralim/IronOS.git
synced 2025-07-23 20:30:38 +02:00
286afad919
* Mock S60 * cleanup * Start refactor of OLED init * Setup timers roughly * Set Vector table offset correctly Update system_stm32f1xx.c * Update OLED.cpp * Update stm32f1xx_hal_msp.c * Update configuration.h * I2C init before GPIO From Errata Update stm32f1xx_hal_msp.c Update Software_I2C.h Allow no hardware I2C * I2C BB run bus unlock at init * cleanups * Software I2C for now * Mildly more graceful Interpolate * Handle is powered by DC Update Power.cpp Update drawPowerSourceIcon.cpp Update configuration.h Update Setup.cpp * Cleanup HomeScreen * Segment remap oled at init * Cleanup * Update MOVThread.cpp * Fix PWM Init * Fix adc2 trigger * Update configs * Fixup warning * Saner default config * Update ThermoModel.cpp * Util for current@voltage * Hub238 warning * Add hub238 handling in power mode * Update USBPDDebug_FUSB.cpp * HUSB238 debug * Hook PSU Limit * Use wrapping section of GRAM for scroll Update OLED.hpp * Update NTC table * Fix HUB voltage picker * Cleanup * Larger tip filter * Calibrate in a bunch closer Update ThermoModel.cpp * Update configuration.h * Update HUB238.cpp * Update configuration.h * Movement Pin * Update BSP.cpp * tim2 irq * Rough timer conversion (adc broken) but movement working * Fix tim2 start * Faster base PWM * Ensure utils grabs config * Add wattage limiter tolerance for device * Speed up PWM and enable PWM current limiting * tune for 12v * Prevent start until PD done * Update configuration.h * Add HUB238 check for have re-negotiated * Adjust timer to avoid noise when its possible
23 lines
876 B
C++
23 lines
876 B
C++
#include "configuration.h"
|
|
#ifdef POW_PD
|
|
#include "BSP.h"
|
|
#include "I2C_Wrapper.hpp"
|
|
#include "Pins.h"
|
|
#include "Setup.h"
|
|
#include "USBPD.h"
|
|
bool fusb_read_buf(const uint8_t deviceAddr, const uint8_t registerAdd, const uint8_t size, uint8_t *buf) { return FRToSI2C::Mem_Read(deviceAddr, registerAdd, buf, size); }
|
|
|
|
bool fusb_write_buf(const uint8_t deviceAddr, const uint8_t registerAdd, const uint8_t size, uint8_t *buf) { return FRToSI2C::Mem_Write(deviceAddr, registerAdd, (uint8_t *)buf, size); }
|
|
|
|
void setupFUSBIRQ() {
|
|
GPIO_InitTypeDef GPIO_InitStruct;
|
|
GPIO_InitStruct.Speed = GPIO_SPEED_FREQ_HIGH;
|
|
GPIO_InitStruct.Pin = INT_PD_Pin;
|
|
GPIO_InitStruct.Mode = GPIO_MODE_IT_FALLING;
|
|
GPIO_InitStruct.Pull = GPIO_PULLUP;
|
|
HAL_GPIO_Init(INT_PD_GPIO_Port, &GPIO_InitStruct);
|
|
HAL_NVIC_SetPriority(EXTI9_5_IRQn, 10, 0);
|
|
HAL_NVIC_EnableIRQ(EXTI9_5_IRQn);
|
|
}
|
|
#endif
|